The original smart key: 46 chip, 433Mhz FSK frequency.
Put VVDI XS smart key into VVDI Key Tool Max coil.
Vehicle remote >> Nissan >> Juke >> Juke(2010-2017) KeylessGo ID46 433M >> Generate remote
Generate smart remote success.
Read BCM Code & Password
Plug Xhorse MINI OBD Tool into OBDII port, connect it with Key Tool Max via Bluetooth.
Before programming, check whether ELV is locked.
Immo programming >> Nissan >> Select from system >> Smart >> 4 digits PIN >> Type 5(No slot – button type) >> Start execution >> Read BCM code
Switch ignition on.
BCM code has been read out.
Press “5-digit BCM code calculation password”.
It’ll will calculate 2 passwords:
New password is for the vehicle after 2009;
Old password is for the vehicle before 2009.
This function requires online, press “OK” to continue.
Fill in BCM code
Password have been read out.
This is a 2018 Nissan, so use new password: 0560.
Before programming, turn switch off, open and close driver door to make ELV locked.
Turn on Hazard light.
Program smart key >> Fill in password: 0560
Take all smart keys out of the car, click START button once, turn the security light.
Whether the direction lock has been released? No
You can hear steering lock now release unlocked(steering wheel can move).
Add Smart Remote
Now this vehicle is ready to add smart remotes.
Please follow the steps to complete the match:
- Take all smart keys to be programmed into the vehicle, close & press start button once ,wait for IMMO light to go out(blink 5 times), then turn off ignition switch.
- If add multiple keys, please repeat step 1.
- Place the programmed smart key close to start button, start the car(wait for 10s) then turn off the ignition.
- If the direction lock does not reset, try pressing start button a few more times, open then close the driver door until steering lock registration completed.
Turn Hazard light off to test the remotes.
All work well, and can start engine OK.
This is how to use VVDI Key Tool Max & MINI OBD Tool to add a key for Nissan Navara 2018 successfully.