Xhorse Multi-Prog

Xhorse Multi Prog read and write Land Rover Discovery 4 BCM and KVM module successfully. Bcm #AH22 14F041 AG Kvm #DPLA 19H440 AD Virgin file […]

Today we’ll be talking about something unusual at work: cloning a Bosch ME9.0 ECU from a Volvo S60. An auto electrician we knew contacted us […]

This article provides a step-by-step overview of reading the engine control module from a 2018 BMW X1 equipped with the B38 engine (Bosch MG1CS201 TC298TP), […]

Problem: Xhorse Multi Prog cannot communicate with ECUs. There is no frequency signal output on the gray wire (P1). Multi prog device reported error: Failed […]

On this BMW G12, the right tail light was completely black. The fault was in the tail light data, so instead of replacing the lamp, […]

It’s a 2024 Geely Coolray, and I need to correct the mileage. The panel looks like this: First, remove the instrument panel. To do this, […]

The Land rover airbag SRS Continental control unit is A2C83377600 AH22-14D374-AH. It does not have an external EEPROM, so you will have to read the […]

Question: ​I have a Citroën C4 2.0 HDI with Siemens SID803 ECU (not SID803A), and in the Xhorse Multi-PROG software, this specific ECU is only […]

Problem: Had a problem reading a BMW SME module with Xhorse Multi Prog. Since the recent updates, I’m getting “Connection Failed” on this SME I […]

Problem: Had a problem updating Xhorse Multi Prog programmer.  It said the current firmware version is lower than the minimum supported version V1.4.9. Tried to […]

Xhorse Multi Prog BMW fuel pump module cloning review: BMW F10 fuel pump module EKPM3 cloning – no problem. Recieved used one for replace with […]