Xhorse ECU programmer

Read and write Renault Megane 3 UCH (v850 processor) with Xhorse Multi Prog programmer. Check the wiring diagram pinout to multiprog. In multi-prog software, don’t select 4-Immobilizer->Renault->Megane […]

Xhorse Multi Prog programmer new user review: Audi A6 C5 cluster swap: cloned via BDM On this cluster the immobilizer is built in, so the […]

Xhorse Multi Prog read Hyundai/Kia 4D immobilizer box control unit module. Module number: 95420-H0000 Hyundai i30 Immo Box (STM8AF6266)    

Xhorse Mult Prog cloned a GM Delphi MT80 engine ECU successfully.   It’s a Chevrolet Cruze 1.6 MY2010 with a Delphi MT80 ECU. Read and […]

Following VVDI Key Tool Plus, Xhorse Multi Prog programmer now also reads 2020.06- BMW locked BMW B48/B58 DMEs.   Supports reading 2020.06- BMW locked B48, […]

Problem: Tried to read a TMS370 using Xhorse Multi Prog programmer and an XDNP47 adapter. But it doesn’t work with Multi-Prog because this one is […]

Xhorse Multi Prog new user feedback: Cloning a Renault Kangoo/Mercedes Benz Citan BCM-N3 (Renesas V850 MCU) using Multi prog programmer. Read the P-Flash (program memory) […]

Xhorse Multi Prog read and write Land Rover Discovery 4 BCM and KVM module successfully. Bcm #AH22 14F041 AG Kvm #DPLA 19H440 AD Virgin file […]

Today we’ll be talking about something unusual at work: cloning a Bosch ME9.0 ECU from a Volvo S60. An auto electrician we knew contacted us […]

This article provides a step-by-step overview of reading the engine control module from a 2018 BMW X1 equipped with the B38 engine (Bosch MG1CS201 TC298TP), […]

Problem: Xhorse Multi Prog cannot communicate with ECUs. There is no frequency signal output on the gray wire (P1). Multi prog device reported error: Failed […]

On this BMW G12, the right tail light was completely black. The fault was in the tail light data, so instead of replacing the lamp, […]