Xhorse VVDI Key Tool Plus is able to add a new key for Mercedes Benz Sprinter W906 2010 via OBD successfully. This is a quick demo to show the operation process.
- Read & Save EIS Data
Connect VVDI Key Tool Plus into OBD, press
Immo programming >> Europe >> Benz >> Automatically diagnose models >> Start programming
There is 1 time for free MB password calculation.
Buy 1 MB Token/ 10 MB Tokens if not enough.
Yes >> Process Wizard mode >> Begin
The current type is W906, press “Yes” to continue.
It shows the basic EIS info and all keys.
Save to file >> Save here >> OK
Yes: key adding
No: all key lost
- Data Acquisition & Upload Password
Insert working key to EIS before press “OK”.
Take working key out of EIS before press “OK”.
Insert working key to EIS before press “OK”.
(If car with keyless go function can not finish synchronize, please try:
insert key and start engine >> switch off >> switch on)
Insert working key to VVDI Key Tool Plus IR reader before press “OK”.
Processing data acquisition takes about 5 minutes.
Just waiting…
Insert working key to EIS before press “OK”.
Insert working key to Key Tool Plus IR reader before press “OK”.
OK >> Save here >> OK
Acquisition finished, upload the saved data with “Upload data” for password.
Upload success!
Calculating will requires 50s…
Successfully found password. It has been copied to the clipboard and can be used directly.
- Prepare Key File
Load the EIS file with password >> Select last saved file >> Yes >> OK >> v051
Calculating, require 30s…
OK >> Save here >> OK
Key file generation completed.
- Write Key File
Load the key file to be written >> Select an unused key: key3
Insert the new VVDI BE Key into the infrared antenna of Key Tool Plus.
Writing data success.
If key is smart key(BE), please install battery and wait 1 minute before learn key to car!(The key LCD will flashing during this time)!
Insert the written key into EIS to activate.
If cannot activate, please try:
- Manual activation by select from: read write key >> read/write key via IR >> activate;
- Read EIS data again and generate key file again;
- Try to unplug the OBD connector, insert the BE key into EIS to activate.
- Test Key
The new key can start the engine. And its remote is OK.
Key adding has done!
This is how to use XhorseI Key Tool Plus to add a Mercedes W906 remote by OBD successfully.