Main steps:
Read KVM RFA data
Write Key
Rewrite data
Step 1: Read KVM Data
Remove the KVM module
Locate IC Chip RFA MC95S12XET265
In VVDI Prog software, select Land Rover->RFA Unsecured (MC95S12XET265)
Check connection diagram
Connect KVM module with vvdi-prog through MC9S12 adapter
Read D-Flash and save data
Read EEPROM and save data
Step 2: Write Key with VVDI2
In VVDI2 software, select Transponder Programmer
Select Euro->Rover->-Rover/Jaguar 2015-
Load RFA DFLASH and EEPROM data respectively
select a unused key position
Insert new key into VVDI2 programmer
Select Make Dealer Key
Prepare dealer key success.
Write the new dump file to RFA module with programmer
Check key status
Show key ID. The key can start the car.
Step 3: Rewrite Data
In VVDIProg software, open EEPROM and write new dump to RFA module
Open and upload DFLASH and write new dump to RFA module
Install RFA module to vehicle.
Test thew new key.
Done.