Question:
Can I clone with Xhorse Multi Prog on a Peugeot Valeo VD56.1 ECU? I tried writing, it works fine, no problems, but I don’t have a startup after writing the flash and eeprom?
Here is the clue.
Multiprog reads VD56 ECU in boot mode without problem, but it cannot 1:1 clone this ECU. There is an OTP on it.
Multiprog does not calculate the checksum for the VD56.
Multiprog read mcu id if you need immo off you need mcu id.
This mcu has otp areas and mcu id so if you write the mcu will block.