Today I’m siting in a 2013 Mercedes Benz C63 AMG. And I’m going to program a BE Key with Xhorse VVDI Key Tool Plus for this car by OBD. We’ll also need an original key in the procedure.
Connect VVDI Key Tool Plus into OBD.
Pull the Start button out on this.
Read & Save EIS File
Remote programming >> Benz >> Automatically diagnose models >> Start programming
It’s telling me we have 7 times for paid calculation, so you need to have enough MB Tokens before going on.
Yes >> Process wizard mode >> Begin
The current type is W172, 204, 207, 212(with ELV), press “Yes” to continue.
Press “Yes” to save the password to EIS file.
In this page, we can see we still have 3 key slots left over.
Press “Yes” to do key adding.
Insert working key to EIS before press “OK”.
Take working key out of EIS before press “OK”.
Insert working key to EIS before pressing “OK”.
If car with keyless go function can not finish synchronize.
Please try the following step: insert key and start engine >> switch off >> switch on
Insert working key to Key Tool Plus IR reader before press “OK”.
Insert working key to EIS before press “OK”.
Insert working key to Key Tool Plus IR reader before press “OK”.
Click “OK” to save collection data.
Acquisition finished. Upload the saved data with “Upload data” for password.
Upload success!
It’s getting password calculation…
Successfully found password. Press “OK”.
Press “OK” to load EIS file with password.
Select “v051”.
It’s calculating, require 30s…
Save data file.
Key file generation completed.
Press “OK” to load the key file to the written.
Write Key File
Inset the new VVDI BE Key Pro into the infrared antenna of Key Tool Plus.
Press “OK”.
Writing data success.
If key is smart BE key, please install battery and wait 1 minute before learn key to car!
(The key LCD will flash during this time)
The activatation key generally directly inserted into the car to activate. If you cannot activate, please try the following methods:
- Manual activation by select from system >> Read write key >> Read/write key via IR >> Activate.
- Read EIS data again and generate key file again.
- Try to unplug the OBD connector, insert the BE key into EIS to activate.
Insert the key into the infrared antenna of the Key Tool Plus.
Press “OK”.
This key is all programmed. Just make sure it’s working.
Beautiful, it can start the car, lock & unlock do work well.