How to use Xhorse Mini Prog + VVDI Key Tool Max to program a dealer key M95320 for 2013 Volkswagen Passat CC? Today I’ll demonstrate it on bench.
Read & Save EEPROM
Remove the outer shell to take out chip.
Hold and push Mini Prog straight down on the M95320 chip.
Press on Key Tool Max meanwhile,
EEPROM and FLASH >> ST >> M95XXX >> M95320(pressure) >> Read >> EEPROM >> Start operation >> Continue >> Rename, OK
(Note: DO NOT lay down Mini Prog during reading.)
Read & save EEPROM file successfully.
The Mini Prog screen will show an OK button, which means “Done”.
Program Dealer Key
Switch to Xhorse Key Tool Max function page, press
Special function >> Immo data tool >> Europe >> VW >> Passat >> Comfort ID48 – 95320 >> Start execution >> Load EEPROM file
Select an unused key position: key 4, press “Prepare dealer key”.
Select “Megamos 48”.
Place a new key into Key Tool Max coil.
OK >> OK
Prepare dealer key success.
It can start engine after write back new dump file.
Press “OK” to save the new dump file.
Rename, save >> OK
Let’s go back to Xhorse Mini Prog page to write new dump file.
EEPROM and FLASH >> ST >> M95XXX >> M95320(pressure) >> Write >> EEPROM >> Start operation >> Select dump file to load
Turn on Mini Prog and hold it straight on M95320 chip again.
Start operation >> Continue
(Note: DO NOT lay down Mini Prog during writing.)
Write completely.
Key programming has done!
Program 2013 VW Passat CC a M95320 key with Xhorse Key Tool Max & VVDI Mini Prog was successful!