Xhorse Dolphin XP007 Cannot Slide Back and Forth Solution

November 28, 2022 VVDISHOP Xhorse Key Cutting Machine 0

Problem: I had a problem with my Xhorse dolphin xp007 manual key cutting machine. Can’t slide back and forth, can only spin in circles. Any solution?

Xhorse Dolphin Xp007 Cannot Slide 1

Xhorse Dolphin Xp007 Cannot Slide 2

The workstation (Y direction) cannot slide or shake back and forth solution:

Step 1: Turn the device over. Check if there is something stuck in the sliding gap of the bottom rail.

Xhorse Dolphin Xp007 Cannot Slide 3

If yes, clear dirty stuff

If no, do Step 2.

 

Step 2: Adjust the 2 Kimi screws on the right side against the guide rail, and move the cross slide back and forth. If the cross slide is smooth and not stuck, tighten the 8 screws immediately

Xhorse Dolphin Xp007 Cannot Slide 5

 

NOTE:

Tip: If the 8 screws are loosened, do not tighten the 8 screws immediately. The 2 Kimi screws on the right side need to be adjusted to ensure that the cross slide moves smoothly before tightening the 8 screws.

Related posts:

  1. How to Disassemble Xhorse Dolphin XP007 Cover to Check Battery?
  2. Xhorse Dolphin XP007 Remove Broken Tracing Probe that Stays Stuck
  3. How to use Xhorse Dolphin XP007 to cut flat key, civilian key, single-sided key etc?
  4. How to Setup & Calibrate Xhorse Dolphin XP007 Key Cutting Machine?