This is the 2020 Land Rover vehicle information, which has been replaced chip. So I’m gonna use Xhorse VVDI Key Tool Plus to program RFA at first, then add 2 smart keys.
Connect Key Tool Plus Pad into OBD, go to:
Immo programming >> Land Rover >> Land Rover(2018-) >> Smart key system >> Replace RFA(Beta) >> OK >> OK
The program will automatically switch on the ignition, please confirm that the current vehicle ignition is off.
The following process will perform the RFA module data programming function. If the current RFA module has performed a complete data programming, you can skip this process. Click “OK” to perform the data programming function, click “Cancel” to identify enter the key matching process without performing the data programming function.
Press “OK”.
VVDI Key Tool Plus is configuring the system, wait until 100%…
RFA module data programming is completed. If you need to try to match the key multiple times, you can skip the RFA module data programming and directly execute the key matching process.
The Xhorse key tool plus program will automatically switch on the ignition, please confirm that the current vehicle ignition is off.
Please prepare at least 2 keys that need to be matched, and the keys need to be placed in the car. During the matching process, you need to press the unlock button. After clicking “OK”, start matching keys according to the operation prompts. Please complete all keys within 30s.
Please take the matching smart key in your hand.
Press the unlock key for 4s, and the born sounds twice, which means the matching is successful.
Programmed successfully.
Press “Yes” to program next one, otherwise press “No”.
2 keys have been added, go ahead to have a test.
Both can work normally.
Done.
