Problem:
The clamp that comes standard on the Xhorse Dolphin XP007 doesn’t work when you try to make micro-adjustments to the screws above the laterality numbers, such as 1 and 2, and the depth numbers 3 and 4. It doesn’t make the micro-adjustments, leaving the key copies defective. It’s impossible to get them adjusted.
Solution:
1. Install two identical probes
2. Install the same blank HON66
3. Adjust the left and right 1 and 2. You need to loosen both 1 and 2 first
4. If the indicator is not turn on, tighten the top screw on that side
Then try again.
