How to Cut HON66 Key with Xhorse Condor XC-002 PRO?

This is a tutorial on how to cut a HON66 key with Xhorse Condor XC-002 PRO. Always remember the key cutting machine was well-calibrated(Height Level Adjustment) before working.

 

Height Level Adjustment

Method 1.

  • Insert the original key with the help of a guiding block. Use a shim to make sure the key is well aligned.
  • Insert the key blank to the right for ready.
  • Press down the main handle and check the indicator light. Follow the direction of the light and rotate the micro-adjust knob until the middle light turns green.

Xhorse Condor Xc 002 Pro Cut Hon66 Key Instruction Guide (1)

Xhorse Condor Xc 002 Pro Cut Hon66 Key Instruction Guide (2)

Xhorse Condor Xc 002 Pro Cut Hon66 Key Instruction Guide (3)

Xhorse Condor Xc 002 Pro Cut Hon66 Key Instruction Guide (4)

Xhorse Condor Xc 002 Pro Cut Hon66 Key Instruction Guide (5)

Xhorse Condor Xc 002 Pro Cut Hon66 Key Instruction Guide (6)

Method 2.

If you don’t have a shim momentarily, follow the method as below.

  • We can also use probes of the same specification on both sides to ensure the accuracy.
  • Press down the main handle and rotate the handle to lock it. Utilize the probe and cutter of Condor XC-002 PRO machine for key alignment.
  • Replace the cutter back and adjust the micro-adjust knob until the middle light turns green.

 

Height level adjustment was finished.

Xhorse Condor Xc 002 Pro Cut Hon66 Key Instruction Guide (7)

 

Preparation

Before cutting, take a look at the clamp. There are 3 marked positions at the bottom of the clamp: A, B and C.

  1. Slide in the clamp and make one triangle directs to the line depending on your need.
  2. Turn on the power switch of the cutter, adjust the speed control knob to a suitable speed.

Xhorse Condor Xc 002 Pro Cut Hon66 Key Instruction Guide (8)

 

Cut HON66 Key

Now let’s start duplicating the key.

  1. Press down the main handle and start cutting the first side.
  2. After finishing, turn off the power switch. Clean up the clamp and flip the key.
  3. Similarly align the key and finish calibration of the other side.
  4. Turn on switch to cut the other side of key.

 

*Please remember to turn off the power when completed.

 

Now the new HON66 key cutting has been finished.

Xhorse Condor Xc 002 Pro Cut Hon66 Key Instruction Guide (9)

Xhorse Condor Xc 002 Pro Cut Hon66 Key Instruction Guide (10)

 

www.vvdishop.com