How to duplicate the new Honda emergency keys with the Xhorse Dolphin XP005L with M5 Clamp?
Here are the tips to cut New Style Honda Emergency key cut on the Xhorse Dolphin II or Condor II?
Select 2021+ Civic and then profile HONDA. Or newer MDX and profile ACURA.
The two sides of the key are cut differently. Take a very careful look at the tip of the key, one side is wider than the other.
A axis should have you with the key-ring connector facing up into the air. Decode A axis and then cut A axis.
Then switch machine to B Axis. Decode customer key with key ring connector facing down to the floor, then cut new key B axis.
Honda has introduced a new keyway for its 2021 and newer smart keys. These emergency keys are thinner, double-sided, and made of steel in their OEM form. However, for easier cutting, brass keys can be used as an alternative. In this guide, we’ll walk through the process of cutting one of these keys using the Xhorse Dolphin 2 key-cutting machine.
Key Features of the New Honda Emergency Key
Double-Sided Design: The key has an “A” side and a “B” side, each with distinct cuts.
Thin Profile: The key is noticeably thinner than previous models.
Material: OEM keys are steel, but brass keys are easier to cut and work well for duplicates.
Step-by-Step Cutting Process
1. Identifying the Key Sides
Before cutting, it’s crucial to identify the “A” and “B” sides of the key:
A Side: Look for a small slope at the tip of the key when held in a specific orientation.
B Side: When flipped over, the slope will appear in the opposite direction.
2. Setting Up the Xhorse Dolphin 2
Navigate to the key selection menu on the Dolphin 2. The new Honda key is labeled as “SY” in the machine (note that this naming may vary).
Enter the cut codes obtained from decoding the lock. In this example, the cuts for the “A” side were 3 5 1 3 1.
3. Cutting the “A” Side
Secure the key in the machine’s vice with the “A” side facing up.
Select Line 3 as the reference point for clamping.
Initiate the cutting process and allow the machine to complete the cuts.
4. Cutting the “B” Side
Flip the key over and secure it again with the “B” side facing up.
On the machine’s screen, switch from the “A Side” to the “B Side” option.
Enter the cut codes for the “B” side (in this case, 3 5 4).
Proceed with cutting the “B” side.
5. Finishing and Testing
Remove any brass flakes or debris from the key after cutting.
Test the key in the lock to ensure it operates smoothly. The key should only insert one way and turn without issues.
Tips for Success
Double-Check Orientation: Always verify the “A” and “B” sides before cutting to avoid errors.
Use Brass for Practice: If you’re new to cutting these keys, brass blanks are more forgiving than steel.
Conclusion
Cutting the new Honda emergency key on the Xhorse Dolphin 2 is straightforward once you understand the double-sided design and proper orientation. By following these steps and paying attention to detail, you can create a functional duplicate key with ease.