This post is showing how to use Xhorse VVDI Key Tool Plus Pad to clone and generate a VVDI Super Chip key for 2015 Nissan Rogue.
Tools required:
Original key
New blank key
Xhorse Condor XC-009 key cutting machine
Procedure
- Clone Key
Put the original key into VVDI Key Tool Plus coil, press
Transponder clone >> Read transponder
Confirm the transponder is 46 type.
Transponder clone >> Start clone >> Transponder clone
Just follow the notes:
Do not remove the original key.
Reading data successfully.
Take out the original key, put a VVDI Super Chip into Key Tool Plus coil.
Copy successfully.
Press “Complete”.
- Cut Key
Install the programmed Super Chip into the blank key.
Here we go to Condor XC-009 machine.
Place original key on guide clamp while blank key on cut clamp.
Check the spacing and tip alignment.
Then start to cut.
- Program Key
- Insert original key into ignition to start the vehicle.
- Once running and all dash lights are off. Remove the original key and use new key to start the vehicle.
If vehicle starts normally, which means the key was successfully programmed.
Done!