Xhorse MVCI PRO J2534 Passthru Cable is designed for multi-vehicle and multi-protocol diagnostics, compatible with D-PDU and J2534 diagnostic standards.
It can meet mainstream automotive industry standards to support multiple automotive manufacturers like Audi, Lamborghini, Bentley, VW, Toyota, Honda, Ford, Subaru, Mazda, etc. Besides, it also supports CAN, CAN_PS, ISO15765…various communication protocols.
These original diagnostic software (ODIS, TIS, HDS, SSM4, Ford IDS, Mazda IDS) are currently compatible and more will be updated.
How to use Xhorse MVCI PRO?
Click “Connect” in MVCI PRO software – here we can view device info like firmware version number, serial number, etc.
Read Authorization – here we can read the device authorization status & available times.
Update Authorization – here we can update the latest authorization status & reset the available times.
Vehicle Diagnosis – here we can install the driver required for the corresponding brand so that the operation on the original diagnostic software is successful.
Upgrade – here we can upgrade software & firmware.
Xhorse MVCI PRO Replace VW VAS6154
For Volkswagen, Xhorse MVCI programming cable supports PDU protocol and can replace VAS6154. The detailed steps are as follows:
- Open the MVCI PRO software: Vehicle Diagnosis >> Volkswagen, uninstall the existing driver first and then install.
- Click “Yes” to install the 6154 mode, which is compatible with the PDU protocol.
- Click “No” to install the 5054 mode, which is compatible with the PassthruJ2534 protocol.
- Click “Yes” to finish the installation.
Xhorse MVCI PRO Diagnose HONDA
- Connect MVCI PRO J2534 cable between the vehicle module & computer.
- Run HONDA original diagnostic software to automatically read VIN number. If the VIN hasn’t automatically filled in, we’d better check whether the cable connection is successful. If the OBD voltage is detected, the signal light will be solid green.
- Click “Honda System”, here will provide a list of systems. We can perform diagnostics as needed.
Eg. Click “ONE-PUSH START >> KEYLESS ACCESS CONTROL Unit >> DTCs”, here will display the diagnostic trouble code & related description.
To clear DTCs. Click the 4th icon on the right, then press ENTER to clear codes.
Now the DTCs have been cleared.
So we can use the same method to diagnose other systems.
