Program VW Passat B7 ID48 Key with Xhorse VVDI Prog+ VVDI2

How to: program VW Passat B7 ID48 Key using Xhorse VVDI Prog+ VVDI2.

Here we have a working key so need to add a spare key. The easiest way is to clone ID48 transponder with vvdi mini key tool. Here we did it with vvdi prog and vvdi2 because have no id48 token. Same procedure if all keys lost.

Vvdi2 Passat B7 Id48 Add Key 1

Run VVDI2 software->VW->4th Immobilizer system- VW/Skoda/Seat->VW Passat/CC Key Learn

Vvdi2 Passat B7 Id48 Add Key 2

Vvdi2 Passat B7 Id48 Add Key 3

Select OBDII Read Login Code+ Part memory data

Vvdi2 Passat B7 Id48 Add Key 4

You can read engine ECU, get PIN, CS
Switch ignition OFF, then switch ON

security access failed, vvdi2 cannot read the login code for current ECU.

Vvdi2 Passat B7 Id48 Add Key 5

So we need to remove comfort module to read eeprom

Remove comfort module, read m95320 data with vvdi prog
Save original dump

Vvdi2 Passat B7 Id48 Add Key 6

Vvdi2 Passat B7 Id48 Add Key 8

Vvdi2 Passat B7 Id48 Add Key 9

Vvdi2 Passat B7 Id48 Add Key 10

Assemble the comfort module and install it back on the car.

 

Go to VVDI2 again
VVDI2->VW->4th Immobilzier system- VW/Skoda/Seat->VW Passat/CC Key Learn->Load Comfort Module EEPROM (95320)

Upload eeprom just saved

Vvdi2 Passat B7 Id48 Add Key 12

Vvdi2 Passat B7 Id48 Add Key 13

Select Get PIN, VIN and search 7 bytes CS from dump file

decrypt 95320 dump file

Vvdi2 Passat B7 Id48 Add Key 14
Vvdi2 Passat B7 Id48 Add Key 15
Find 7th byte success
Make dealer key with 7 bytes CS

Vvdi2 Passat B7 Id48 Add Key 16
Put new key into vvdi2 programmer

Vvdi2 Passat B7 Id48 Add Key 11
Make dealer key success

Vvdi2 Passat B7 Id48 Add Key 17

Input number of keys to learn: 2
Select Key Learning
Press OKAY button to start learning. Insert dealer key into car and switch it on for at least 2 seconds.
Then change next key within 5s.
Learn key successfully

Vvdi2 Passat B7 Id48 Add Key 18

Vvdi2 Passat B7 Id48 Add Key 19

New key will start key successfully.

You need to program the ID48 chip or the transponder separately.

The remote should be adapted separately.

Get the remote programmed by vcds cable.

Done.