Problem:
I want to clone this Chevrolet Cruze BCM D70F3469 using Xhorse multi prog, but I’m getting this error.
Error: Chip configuration failed. Error code 08030201. Crystal frequency does not match.
Solution:
Check your connections. Need a 120 ohm resistor between the two CAN H and L wires. Between CAN H and L, just jumper those wires with the resistor.
A 120 ohm resistor is required on the CAN L and H wires, since their communication uses the resistance security system, implemented in the communication network of these units. This is intended to provide additional protection against diagnostics from the OBD2 port. If the circuit is opened by resistance, communication with the corresponding modules is lost. If you want to scan the vehicle and certain modules don’t communicate, by sheer logic, everything is derived thanks to the diagnostic protocol.
