How to check if your Xhorse Condor XC-Mini Plus II key cutting machine has conductivity issue?
Part I: Do a Conductivity Test in Condor II
In Condor II main menu, go to Settings->Machine Test-> Electrical Conductivity Measurement->Start Test
Part II: How to check Condor II if it has conductivity issue
Check instruction below:
1. Remove those those screws for take off machine screen
2. Pull out the whole motor to expose the whole motor case and remove those screws to take off motor case
3. After remove the motor case , the cable which related conductivity it will expose, please check if that cable has any damaged
4.This cable go though whole mian motor, one side connect with led bar and one side connect with probe base ,for remove that cable it need to remove the cable socket and then pull it out from bottom led bar side .
5.Loosen the fixing screw of the conductive wire as shown above and remove the LED lamp cover.
6.Remove the three fixing screws, note that there are three black plastic parts on the screws, do not lose them.
