Problem:
Xhorse Multi Prog programmer failed to read BMW Bosch MG1CS201 ECU on bench. It said connection failed. How to solve it?
Solution:
Do as the software prompts.
Add an external 120-ohm resistor between S6 and S14.
Then try again.
Problem:
Xhorse Multi Prog programmer failed to read BMW Bosch MG1CS201 ECU on bench. It said connection failed. How to solve it?
Solution:
Do as the software prompts.
Add an external 120-ohm resistor between S6 and S14.
Then try again.
Copyright © 2026 | WordPress Theme by MH Themes