This is the keyless entry module out of an Audi A3 2014. This car is water damaged and we can clone this one. Xhorse Multi Prog will read and write this module.
Open the control module.
Go to MCU function and select the chip we need-9S12XET256 secured. It is an MCU type 9S12 and it is a secured one.
It will show the MCU wiring diagram.
If we go on VW we can also see the same MCU. This is really nice.
This is the connection. If we choose from vehicle, it also shows us the board connection.
Multiprog shows us that you should pay attention and remove these components.
Soldering according to this diagram.
Read D-flash. It has no data.
Let’s read EEPROM and Pflash.
Read POF, there is no data. It is normal.
Then we write the backup data to the donor kessy module to clone this module.