Does xhorse vvdi bimtool pro support E series 8HP EGS?
No, there is no 8HP in E series in the menu.
VVDI BIMTool Pro supports BMW E series 6HP, F series 6HP and F series 8HP.
VVDI BIM Tool BMW EGS Function Introduction:
Read gearbox status: Support to read 8HP gearbox status, whether it is a new, etc
Diagram: OBD and gearbox connection diagram
Backup coding: Back up the code in the gearbox
Restore coding: Restore the code in the gearbox
Clear the F-Series 8HP Gearbox ISN: Clear the internal information that have used which have been matched and make them to new part
Reset F-8HP adaptation: Restore the adaptation information in the gearbox to the initial status
Reset F-6HP EWS: Restore the immo information in the gearbox to the initial status
Read E-6HP ISN (E70, E65 and E63): Read the ISN information from the gearbox, it is possible to get several ISN values, but only one is correct. The ISN you get is 4 bytes, the first 2 bytes are the gearbox ISN, and the last 2 bytes are the DME ISN. The gearbox byte is encrypted, and the DME byte is not encrypted. If the ISN read from DME is same as last 2 bytes ISN read from gearbox, it is the correct ISN
Reset E-6HP EWS: Restore the IMMO data in the gearbox to the initial status
Reset E-6HP adaptation: Restore the adaptation information in the gearbox to the initial state